Outback Power Systems FLEXmax 60 - Page 20

19
System Voltage Screen
Press the <YES> soft key to proceed if the selected
battery voltage is correct. If incorrect, press <NO> to re-
enter the correct voltage. The <YES> soft key will open
the STATUS screen.
Are you sure?
12 24 36 48 60
^^
NO Yes
NOTE: Repeating the Powering Up sequence resets the
Charge Controller Charge Controller to its factory default
settings (see page 77).
Are you sure?
English
NO YES
Press the <YES> soft key to con rm your choice or
<NO> to return to the SELECT VERSION screen.
The Charge Controller auto detects the system’s battery
voltage. To con rm this voltage, press the <ENTER> soft
key. If incorrect, press the “ ” soft key to select a battery
voltage. The Charge Controller’s default values are based
on a 12VDC system. Selecting a higher voltage system
will change all the default values (e.g., the values will
double with a 24VDC system, triple with a 36 VDC system,
etc.). “^^” indicates the chosen voltage. The Charge
Controller will automatically accept the selected battery
voltage if left unattended for 5 minutes in this screen.
After choosing the voltage, press the <ENTER> soft key
to proceed.
Veri cation Screen