15
K. Troubleshooting
Problem Possible Cause Solution
Burners will not light using the
ignition system
LP gas cy linder is em pty Replace with full cylinder
Faulty regulator Have regulator checked or replace
Obstructions in burners Clean burners
Obstructions in gas jets or gas hose Clean jets and gas hose
Electrode wire is loose or disconnected on
electrode or ignition unit
Reconnect wire
Electrode or wire is damaged Change electrode and wire
Faulty integral ignitor Change ignitor
Burner will not light with a match
LP gas cy linder is em pty Replace with f ull cy linder
Faulty regulator Have regulator checked or replace
Obstructions in burners Clean burners
Obstructions in gas jets or gas hose Clean jets and gas hose
Low fl ame o r flashb ack (fir e in
burner tube— a hissing or
roaring noise may be heard)
LP gas cylinder too small Use larger cy linder
Obstructions in burners Clean burners
Obstructions in gas jets or gas hose Clean jets and gas hose
Windy conditions Use BBQ in a more sheltered position
Gas valve knob difficult to turn
Integral ignition system jammed Replace integral ignitor
Gas valve jammed Replace gas valve
For reference and correspondence,
record your serial number here.
(See sticker on side of barbecue body.)
Serial No.__________________
This number may be required when
ordering spare parts or accessories. A
part reference number may also be
required where applicable.
Published November 2005’
To Previous Page
Loading...
Need help?
General
