OWC Data Doubler Installation
56
16. Carefully place the Data Doubler into the optical bay; Be careful not to
damage any loose cables or connectors. Next, take two of the longer
Phillips screws from the kit and ax them in the same locations (highlighted
in red below) where you removed the shorter screws in Steps 9 and 10.
17. Reseat the bracket and cable assembly you set aside in Step 8, then
secure the screw you removed from the silver bracket in Step 7. Ax
the two screws that were removed in Step 8 (highlighted in blue); the
screw closer to the corner is longer and needs to be axed in the same
location. Make sure all the antenna connectors and the ribbon cable are
still connected.
19. Reconnect the ribbon cables and the cable with the silver connector, that
were disconnected in Steps 5 and 6 (area highlighted in yellow). If you
disconnected your battery in Step 2, reconnect it now.
20. Carefully reseat the bottom cover, snapping it back into place. Ax the
10 Phillips screws that were removed earlier; make sure the three long
screws are placed back in their original locations from Step 1.
The installation process is complete. Proceed to Section 3.1 for additional
support information.
To Next Page
Loading...
Need help?
General
