To Next Page

To Previous Page

OWC Data Doubler Installation

2.2 Installation by Laptop type

2.2.1 Late 2008 13” MacBook (5,1) and Mid-2009 13” MacBook Pro (5,5)

IMPORTANT: before beginning, be sure that your laptop is fully shut down

and disconnected from all cables, including the power cable. If you have a

MacBook model 5,1, start with Steps 1-3. If you have a MacBook Pro model

5,5 start with Step 4.

1. Use the release lever (highlighted below in red) to release the battery cover,

then remove it (bottom photo). Recommended: Use the pull-tab on the

battery to remove it from the laptop, then set it aside.

Other manuals for OWC data doubler

Questions and Answers:

Need help?

Do you have a question about the OWC data doubler and is the answer not in the manual?

General