Owon CM2100 - Page 32

29
3. Setting Data Chart record count
a. Set the number of recorded data in the real-time recording interface, and then the data will be
saved and displayed on the real-time recording interface according to the set number of
records;
b. Click Data Chart record count button, and set the number of real-time data records in the
display box below (setting range: 100-3000);
c. After setting the number of records, click Save button to complete the setting of the number of
real-time data records;
d. Click Cancel button or click other part outside the setting box to cancel the current setting
value.