Section 2: Installation
2.4 Packaging
Packaging: default packaging.
Other packaging methods:
A) Wraps with pasteboard or thick plastic.
B) With the intensity big packing case. (Made with such as double-decked cartoon paper)
C) Wraps with 70mm - 100mm sacrificially all around the instrument for quakeproof.
D) Place “the danger” on the packaging.
If the box or blister package has been damaged seriously, please keep it until the instrument and
all the accessories are passed your test.
2.5 Tagging for Service
The tagging is the certificate for the customer to require servicing. So please do not arbitrary tears
and modifies it.
2.6 Power Supply Requirement
Use only the power cord specified for this product and certified for the country of use. Make sure
that the product is properly be grounded.
2.7 Cleaning Requirements
Cleaning
Inspect the instrument and probes as often as operating conditions require.
To clean the instrument exterior, perform the following steps:
1. Wipe the dust from the instrument and probe surface with a soft cloth. Do not
make any scuffing on the transparent LCD protection screen when clean the
LCD screen.
2. Clean the instrument with a wet soft cloth not dripping water, during the
period of which please pay attention to the disconnection of power. It is
recommended to scrub with soft detergent or fresh water. To avoid damage
to the instrument or probe, do not use any corrosive chemical cleaning agent.
Warning: Before power on again for operation, it is required to confirm that
the instrument has already been dried completely, avoiding any
electrical short circuit or bodily injury resulting form the moisture.
9
To Next Page
Loading...
Need help?
General
