oxycom IntrCooll Std. - Operation Procedures; Operating the Unit and Initial Checks

Version 1.3, 2021-12-14 53
1
2
3
4
5
5 Operation procedures
5.1 How to operate the IntrCooll®
5.1.1 Checks before starting
Before starting make sure that:
- All panels and covers of the IntrCooll® are installed.
- There is no marking on the IntrCooll® ‘DO NOT START’.
- There are no loose or strange parts within the IntrCooll®.
- The water supply to the IntrCooll® is connected.
- The correct lters are installed.
- The correct ow regulator cap (50 Hz / 60 Hz) is installed.
- The drain is connected to a local drain circuit
- The IntrCooll® is connected to the mains power supply.
- The maintenance switch is in ON position.
- The padlock switch is in ON postion.
- The thermostat is switched on and connected to the IntrCooll®.
- For correct settings, refer to the enclosed documentation in the thermostat
package.
5.1.2
Check unit installation
Check and nish lling in the Installation checklist on page 48.