Ozito ECS-355 - KNOW YOUR PRODUCT; Accessories; SETUP & PREPARATION; Chain & Bar Installation

1
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
KNOW YOUR PRODUCT
SETUP & PREPARATION
1 Rear handle
2 Cord retainer
3 On/off switch
4 Chainoilllercap
5 Front handle
6 Hand guard/chain brake
7 Chain
8 Guide bar
9 Oil level window
10Sidepanel
11 Bar securing nut
12Buckingspikes
13Barsecuringnutcover(tted)
14Spanner/chaintension
adjustor
1. CHAIN & BAR
ELECTRIC CHAINSAW
ACCESSORIES
1
9 10 11 12
13
2 3 4 6 7 8
14
5
IMPORTANT: IT IS VITAL FOR THE PROPER AND SAFE
OPERATION OF THE CHAINSAW THAT THE CHAIN IS
TENSIONED CORRECTLY.
Fitting a chain and bar
1. Remove the bar securing
nutcoverusingtheatend
of the tool.
2. Remove the bar securing nut
thenthesidepanel.
3. Fit the chain over the
guide bar making sure
that the cutters are facing
in the direction of rotation.
4. Place the guide bar and
chaininpositionensuring
the chain is around
sprocketwheel(B).
Note: If required adjust chain
tension screw to move the
tension lug back to allow the
bartot
B
Before assembling or disassembling a chain be sure to
disconnect the chainsaw from the power supply.
Always wear gloves when handling the chain as it is very sharp
and can cut you when it is not moving.