Ozito ECS-355 - OPERATION; Cord Retainer; Chain Brake

1
3. CORD RETAINER 4. CHAIN BRAKE
OPERATION
1.Makealoopintheend
of the extension lead and
passtheloopthoughthe
hole in the handle and
hooktheloopoverthe
cord retainer.
3. Connect the extension
leadtothepowercord.
2. Pull the extension cord to
secureitinpositionover
the cord retainer.
Routethepowerandextensioncordawayfromtheworkareatoprevent
contact with the chainsaw.
Chain brake
Thechainbrakeoperatesautomaticallyintheeventofkickback.
Thechainsawisttedwithahandguard/chainbrakewhichwhen
operatedbringsthechaintoastopwithinatenthofasecond.
Thecordretainerisusedto“anchor”anextensioncordwhenitis
connectedtothepowerleadofthetool.Itpreventstheextension
cordfrombeingaccidentallydisconnectedfromthetoolpowercable
or shaken loose during use.
Thechainbrakecanbeoperatedmanuallybypushingitforwardor
automatically as a result of kickback.
Kick back occurs if the chain catches on the wood being cut and the
chainsawpushesbacksuddenly.
Intheeventofkickback,yourhand(whichisonthefronthandle
duringoperation)jerksforwardcausingthebackonyourhandtopush
theguardforward,engagingthechainbrakeandquicklystoppingthe
chain.
STOP RUN
BRAKE ON BRAKE OFF
Note:Alwaysuseanapprovedextensionleadsuitableforpowerinputof
this tool.