9
REAR PANEL (cont.)
CABLE IN
Connect the cable service here.
TO TV
Connect to the RF/antenna input on your TV or
VCR (optional).
S-VIDEO
Connect to the S-video input (if present) on your
VCR or TV.
VIDEO OUT
Connect to the composite video input on your VCR
(or a standard TV).
COMPONENT
VIDEO
If your HDTV does not have an HDMI
TM
connector,
connect your HDTV here.
AUDIO OUT
Connect to the L and R audio inputs on your
stereo TV, stereo VCR, or optional stereo amplifier.
DIGITAL AUDIO
OUT
Connect to the electrical digital audio input on
optional digital audio equipment, such as an audio
decoder or home theater receiver.
OPTICAL AUDIO
OUT
Connect to the optical digital audio input on
optional digital audio equipment.
HDMI
(High Definition
Multimedia
Interface)
If your HDTV has an HDMI connector, connect
it here for a digital audio/video connection
(instead of using the AUDIO and three analog
COMPONENT VIDEO connectors).
IR RECEIVE
Connect to an optional remote “eye”.
IR TRANSMIT
Connect to an optional VCR controller (future use).
SATA
Connect to an optional external hard disk
(if enabled by your cable service-provider).
USB
(Universal Serial
Bus)
Connect to compatible optional equipment that
supports a USB 2.0 interface (future use).
ETHERNET
For service use only.
TV PASS MODULE
Connect a TV pass® module, if required.
POWER OUTLET
(for TV only)
Connect your TV’s power cord here to provide AC
power to your TV.
POWER INPUT
Connect your set-top’s power cord here.
Make this connection last of all.
To Next Page
Loading...
