System Operations Manual
www.paceworldwide.com
Page 44 of 50
15. Put the heater cover back on making sure not to pinch hoses or
wires. Reinstall the four screws.
17. Remove the metal retainers from the lower rail assemblies.
18. Remove the installed hex head screw in the rails to avoid the
accidental removal of the reflow head assembly.
19. Reinstall the 4 hex socket head screws on each rail cover on
the left and right sides of the heater.
Figure 51
Figure 52
Figure 53
Figure 54
Figure 55
To Next Page
Loading...
