Pacojet 4 - Page 14

14
© Pacojet International AG 2022
Insert the pacotizing
®
blade into the spray guard.
Attach the combination of the spray guard, pre-
liminary scraper, and pacotizing
®
blade to the tool
coupler on the pacotizing
®
shaft. The pacotizing
®
blade is properly attached when it holds tightly to
the tool coupler.
Note: The tool pot and tool coupler must be
free of residue and must be dry prior to tool
attachment.
Damage by improper attachment of the
pacotizing
®
blade to the spray guard is
possible!
Remove the pacotizing
®
beaker with the food
preparation from the freezer. Remove the beaker
lid. Place the pacotizing
®
beaker inside the protec-
tive beaker.
Insert the preliminary scraper into the spray guard.
Pro tip: The preliminary scraper and spray
guard are newly labeled with PACOJET.
During assembly, both logos should be facing
up.
1
2
3
4
Note: The supplied pacotizing
®
beaker is
made of synthetic material. A pacotizing
®
beaker made of chrome steel as well as its
appropriate protective beaker are available.
PACOTIZING
®