Pacojet 4 - Page 23

To Next Page

To Previous Page

Factory reset: If the device is reset to factory

settings, all data and settings will be lost (e.g.,

favorites). Counter and Event Log will not be reset.

WLAN (3): Characters that can be used to enter

WLAN password and favorites.

WLAN (2): Shows available WLAN networks and

connectivity (Connect).

Note: Acceptance of the Analytics Policy can

be withdrawn at any time.

Counter: Shows the number of processed

portions and cleanings.

1 2 3 4 5 6 7 8 9 0

è # $ % & * - + ( )

é à ! ; / ? , .

+/- X - * ' ´ ` { } ©

£ € ^ @ „ _ = [ ]

< > ! ¢ | \ ? , .

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interferences, and

(2) this device must accept any interference received, including interferences that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Any changes or modiﬁcations not expressly approved by Alator AG could void the user’s authority to operate the equipment.

RSS Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development

Canada’s licence- exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired operation of the device.

3. The compliance distance is zero.