32
© Pacojet International AG 2022
Turn the device off and unplug it.
Carefully remove the protective beaker and the
pacotizing
®
beaker from the shaft.
Carefully lay the device on its side.
Loosen the four baseplate screws with a hex key
and remove the baseplate.
1
4
2
3
The baseplate must be removed if the shaft stops during the pacotizing
®
process and no longer rises up
after the following steps have been performed in order:
• Turn the device off and back on again.
• If the shaft does not automatically rise back up, rotate the protective beaker out and back in.
Allow the mass to thaw a bit if necessary and repeat this step.
• If the problem persists, please contact your certified Pacojet Service Partner. After contact has been
confirmed, proceed as follows:
TROUBLESHOOTING A DEVICE THAT IS LOCKED UP:
REMOVING THE BASEPLATE
To Next Page
Loading...