Pacojet Junior - Checking Scope of Delivery; Device Setup and Environment

15
EN
UnpackthePacojet Junior.Removethepackagingmaterial,adhesivestrips,andprotecve
lmsfromthedevice.
Storethepackagingmaterial(cardboardboxandstyrofoaminserts)
fortransport,storage,andpossiblereturns(e.g.,intheeventof
maintenance).
6.2 Checkingthescopeofdelivery
Checkthecontentsofthepackagingtomakesureallpartsarecompleteandinagood
condion(seeChapter“4.Scopeofdelivery”onpage 10).
Ifyounoceanydefectsormissingaccessories,pleasecontactyourPACOJETsalespointor
yourocialPACOJETservicepartnerimmediately(seeChapter“15.Customerservice”on
page 34).
6.3 Sengupthedevice/underlyingcondionsforsetup
Note
Damageduetooverheang!
Alackofvenlaonmaycausethedevicetooverheatduetopoorvenlaon
andaircirculaon.
• Coolairmustbeabletobesuckedintothebackofthedeviceandblownoutofthe
boomofthedevicewithouthindrance.
• Theairventsmustneverbeobstructedorblocked.
• Posionthedeviceonasafe,stable,at,anddrysurface.
• Arrangethemainspowercablesothatitcannotbedamagedbyedgesorhotsurfaces.
• Themainsswitch(5)mustremainfreelyaccessible
Neveroperatethedevice under the following condions:
• Indirectproximitytoaheatsource
• Onavibrangbase
• Onahotsurface
• Directlynexttoafanoraircondioningunit
• Directlynexttoanoutletformoistorgreasyvapors
• Directlynexttoanoutletforwarmorhotair
• Directlynexttowaterpointsanddevicesthatarecleanedwithawaterhoseorsteamjet
• Withouttherubberfeet
• Whenthegapbetweenthebackofthedeviceandotherobjectsis<10cm.
MakesurethereisenoughroomformovementintheareaaroundthePacojet Junior.Thisis
theonlywaytoguaranteesafeoperaonofthedevice.
Failuretoobservethelistofsetupcondionsmayresultinmalfunconsanddamagetothe
Pacojet Junior.