Pacojet Junior - Troubleshooting Defects

31
EN
9. Defects
Ifthemeasuresdescribedbelowdonotsuccessfullyrecfytheproblemorifyourissueisnot
describedinthelistbelow,pleasecontactyourocialPACOJETservicepartner(seeChapter
“15.Customerservice”onpage 34).
Problem Cause Measure
ThePacojet Junior stops
eventhoughtherequired
quantyhasnotbeen
processed,eitherinfullor
in part.
Theporonquanty
indicator(18)shows“EE”.
Thedevicehasoverloaded.
(Overloadingnormallyoccurs
ifafoodpreparaonrecipe
cannotbeprocessed.)
Switchothedeviceatthe
mainsswitch(5)andthen
switchitbackonagainaer
approx.5seconds.
Iftheporonquanty
indicatornolongershows
“EE”,youcanstartprocessing
furtherbeakersstraightaway.
Iftheporonquanty
indicatorsllshows“EE”
whenthedeviceisswitched
backon,themechanical
overloadprotecon
mechanismhasbeen
acvated.Contactyourocial
PACOJET service partner.
ThePacojetisnot
generanganyposive
pressureduringthe
pacozingprocess.
Thesurfaceofthespray
guard(8)isnotat.Because
thiscomponentmakessure
thattheprocessingsystem
issealed,thesurfaceof
thematerialontheseal’s
lips must be clean and
undamaged.
Checkthesprayguardforany
contaminaonordamage.
Cleananydirtothespray
guard.
Ifthedevicesllfailstobuild
upanypressure,contact
yourocialPACOJETservice
partner.
Thepacozingblade(9)
doesnotengagewiththe
bladeholder(2)anymore.
Thepacozingbladeisheld
bythebladeholderwhenthe
motorisstaonary.Theblade
mayberejectediftheblade
holderorpacozingbladeis
dirty.
Cleantheconneconpiece
andtheholeinthepacozing
blade.
Ifthepacozingbladesll
doesnotengagewiththe
beveledmagnecblade
holder,contactyourocial
PACOJET service partner.