Pacojet Junior - Rinsing Cycle Operation

25
EN
8.1.4 Rinsingcycle
Completethefollowingsteps:
1.
SwitchonthePacojet Junioratthemainsswitch(5).
Thedeviceswitchesto“operangmode”.
Thedeviceisreadyforoperaon.
Ifthedeviceisin“standbymode”,operatethe“START
KEY”toswitchto“operangmode”.
2.
Inserttheemptypacozingbeaker(10)intothe
protecvebeaker(12).
3.
Cauon
Riskofinjuryduetoincorrect
handlingofthepacozing
blade!
• Nevertouchthesharpedgesof
thepacozingblade(9).
• Alwaysholdthepacozingblade
withtwongersatthecorners
betweentheblades!
Insertthepacozingblade(9)intotherinsing
insert(13)byinserngitshollowcomponentintothe
holeintherinsinginsert.
Whiledoingso,makesurethattheatsideofthe
rinsinginsertispoinngdownwardstowardsthe
pacozingblade.