14
Code list TC161
56
Subject to change without notice
Code-
Nr.
Password
protected
Set
value
Limit
-
Limit
+
Unit Title Description
127 no 1 Zyklen Cycle selection after display of end of banding until machine stops
with Error 42
128 no 0 Stück Counter Only in connection with the option "Batch level compensator". After
reaching this value, the batch level gates are set by the batch
counter.
129 no 1000 10000 100 ms Flashing rate of signal indicator
130 no 0
1
nicht aktiv
aktiv
Operation of the banding delivery without package lift
Operation of the banding delivery with package lift.
131 no 1
0
links
rechts
Operation of the package lift on the operator side
Operation of the package lift on the control box side
132 no 1,2,3,4,5
o. 6
Packing cycle The package lift will start after these cycles have elapsed
133 yes 500 500 ms Delay 10 After ejecting the banded stacks, the side loader will start after this
amount of time has elapsed.
134 yes 500 500 ms Delay 11 After conveying the banded stacks to the package lift using the side
loader, the lift table will start after this value has elapsed.
136 yes 100 This time elapses after start is pressed. The machine starts.
138 yes 15 m/min Monitoring of set-up
speed
For press drive
139 yes 8 m/min Monitoring of set-up
speed
For band drive
140 Display for actual sheet length
141 mm Display for the result of the measurement of the last bad sheets.
142 m/min Display for the speed of the transport belts
143 date Last software change
145 cycle Display for cycles until machine stops with Error 42 running out of
banding.
150 yes 0
1
not active
active
By activating Total Reset, all memory will be deleted. All variable
values will be deleted. All code values will return to basic setup
151 yes PW2 0 Erase RAM
152 yes PW2 0 Erase RAM and switch over to programming mode.
To Next Page
Loading...