46/144 INSTALLATION MANUAL - cod. 00 477 0811 - 12/2011 - Palazzetti - PN - Italy
USE AND & MAINTENANCE
Fig. 8.1
8 PRELIMINARY
OPERATIONS
8.1 LOADING THE PELLETS
The pellets are loaded into in the hopper using a
scoop.
Do not empty the sack directly into the hopper so
as to avoid loading sawdust or other foreign bodies
that may affect proper stove operation and avoid
spilling pellets outside of the hopper.
Make sure the hopper lid is well closed again after
having loaded the pellets.
8.2 POWER SUPPLY
Plug the stove into the mains power supply, move
the power switch at the rear of the stove to position
“I” (Fig. 8.1). If the connections are correct the stove
will emit a series of intermittent beeps, the display
will come on and the message “PALAZZETTI
ECOFIRE” will be shown. After 2 seconds the
display will show “OFF” and the second row will
show the operating parameters: POWER, AIR FAN,
SET ROOM T..
On Silent series stoves (no ventilation) the “air fan”
parameter is not featured.
If not using the appliance for an extended period,
the switch at the rear of the stove should be moved
to position (O).
8.3 INITIAL SETTINGS
The language, current date and time need to be set
before using the stove.
8.3.1 language setting
Go to the “STOVE SETTINGS MENU” following the
“Procedure for accessing the menus” described in
paragraph 7.3 and press OK.
1) Scroll the submenus using the or button
2) Use the
button to select the “LANGUAGE”
menu
3) Select the desired language using the
or
button
(“ok”)
5) Press
!!
(“x”) to exit the submenu (press the
same button again if necessary to go back
another menu level).
8.3.2 Time setting
Go to the “STOVE SETTINGS MENU” following the
“Procedure for accessing the menus” described in
paragraph 7.3 and press OK.
4) Scroll the submenus using the or button
5) Use the
button to select the “TIME” menu
6) Select the current day using the
or
(“ok”)
7) Select the current hours using the
or
(“ok”)
8) Select the minutes hours using the
or
(“ok”)
9) Press
!!
(“x”) to exit the submenu (press the
same button again if necessary to go back
another menu level).
8.3.3 Date setting
Go to the “STOVE SETTINGS MENU” following the
“Procedure for accessing the menus” described in
paragraph 7.3 and press OK.
4) Scroll the submenus using the or button
5) Use the
button to select the “DATE” menu
6) Select the current day, month and year desired
using the
or
selection by pressing
(“ok”)
7) Press
!!
(“x”) to exit the submenu (press the
same button again if necessary to go back
another menu level).
To Next Page
Loading...
Need help?
General
