6. Stop the feed pump after 10 L/m
2
of storage solution passes through the module.
7. Disconnect the module from the set-up and cap the ports while keeping Cadence ILC
module full of storage solution.
8. Place the module in a sealed plastic bag.
9. Store module in a temperature-controlled room, optimally at a temperature of 25 °C.
5.5 Part 4 — Post-Use Disposal
Upon completion of the processing and product recovery steps, the module should be
discarded per codes or standards set in your country or region. This may include autoclaving
or incinerating the disposable products (module and tubing). Please refer to standard guidelines
to develop the module disposal protocol.
6. Appendices
6.1 Recommended Storage of New Cadence ILC Modules
Cadence ILC modules can be expected to perform within specifications if, when new, they are
stored and handled in a manner consistent with the parameters below:
• Store modules, unopened in the original packaging, in a dry environment at ambient
temperature up to 20 – 25 °C.
• Protect the module from direct sunlight, radiation, or weather conditions.
• Prevent physical damage while handling.
• Protect the module from thermal shock.
6.2 Delta and Omega Membranes Chemical Compatibility
The chemical compatibility of Cadence ILC modules can be described in terms of changes in
physical characteristics due to continuous contact with a chemical solution for several hours.
Changes can affect dimensions, hardness, swelling, the integrity of internal seals, and
membrane integrity. Changes can also be described in terms of the functional characteristics
of the membrane (such as retention characteristics).
Pall offers validation services to test compatibility of membranes and modules with different
solvents. Contact your local representative for information on Validation Services.
6.3 Alternative Chemical Agents
The User Guides for T-Series cassettes USTR2662 (Delta) and USTR2433 (Omega) offer more
information on appropriate alternative sanitizing and cleaning agents.
Visit us on the Web at www.pall.com/biotech
Contact us at www.pall.com/contact
International Offices
Pall Corporation has offices and plants throughout the world in: Argentina,
Australia, Austria, Belgium, Brazil, Canada, China, France, Germany, India, Indonesia,
Ireland, Italy, Japan, Korea, Malaysia, New Zealand, Norway, Philippines, Poland,
Russia, Singapore, South Africa, Spain, Sweden, Switzerland, Taiwan, Thailand,
United Kingdom, and Vietnam. Distributors in all major industrial areas of the world.
To locate the Pall office or distributor nearest you, visit www.pall.com/contact.
The information provided in this literature was reviewed for accuracy at the time
of publication. Product data may be subject to change without notice. For current
information consult your local Pall distributor or contact Pall directly.
Corporate Headquarters
Port Washington, NY, USA
+1 800 717 7255 toll free (USA)
+1 516 484 5400 phone
European Headquarters
Fribourg, Switzerland
+41 (0)26 350 53 00 phone
Asia-Pacific Headquarters
Singapore
+65 6389 6500 phone
© 2018, Pall Corporation. Pall, , Allegro, Cadence, Omega and Palltronic are
trademarks of Pall Corporation.
Filtration.Separation.Solution
is a service mark of
Pall Corporation. ® indicates a trademark registered in the USA and ™ indicates a
common law trademark.
10/18, PDF, GN18.10100 USD 2841c
To Previous Page
Loading...
Need help?
General
