Setting Up
4
■ One USB port or available serial port (serial cradle/cable sold separately)
Minimum requirements: Macintosh
■ Apple Macintosh or compatible with a Power PC processor
■ Mac OS 8.51 to 9
■ One USB port or available serial port (serial cradle/cable sold separately)
■ 25 MB available hard disk space
■ 6 MB free RAM
Internet Access
For easiest activation of your wireless account, and to receive updates to the
MyPalm™ application, your desktop computer must have the following:
■ A modem
■ An account with an internet service provider
■ A web browser
If you are upgrading from another Palm OS
®
handheld:
If you already own a Palm OS handheld, you must install the version of Palm
Desktop software that comes with your new handheld. Also, perform a HotSync
®
operation using your old handheld and cradle before you complete the set up
tasks. This ensures all data on your handheld is on your desktop computer.
Step 1: Connect the HotSync cradle
Step 2: Charge your Handheld
Just place your handheld on the cradle for two hours for an initial charge before
you use it. Then, place it on the cradle for a few minutes each day to recharge it to
Shut down and turn off your computer.
Plug the USB connector into a USB port on your
computer.
Connect the power cord that attaches to the back of
the cradle’s USB port connector to the AC adapter
cord.
Plug the AC adapter into any AC current outlet.
To Next Page
Loading...
