Section 3B: Sprint Power Vision 111
Sprint Power Vision
4. Make sure your device’s phone is turned on (see “Turning Your Device’s Phone On and
Off” on page 55) and that one of the Power Vision icons ( or ) appears at the top
of the screen.
5. On your computer, open the Sprint Connection Manager software, select your device
name, and then click Connect.
6. Once the connection is established, launch an Internet session, check your email, or
do anything else you would do using a traditional Internet connection.
7. When you’re ready to terminate the Internet connection, double-click the Sprint
Connection Manager icon in the taskbar in the lower-right corner of your computer
screen, and then click Disconnect to end the session.
Note:
If neither icon appears, you cannot use your device as a modem with
Sprint Connection Manager.
Note:
While your Power Vision data connection is active, you can receive
incoming calls and place outgoing calls; however, doing either of these
suspends the data connection until you hang up the call.
Sprint Vision services are available on the Sprint National Network.
Sprint Power Vision services work anywhere on the network, but
broadband-like download speeds are available only in areas with
high-speed data coverage.
To Next Page
Loading...
Need help?
General
