Locating handheld components
13
Using the backlight
If lighting conditions make it difficult for you to see the information on your
handheld, you can adjust the brightness of the screen backlight.
To adjust the brightness of the backlight:
1. Tap the Brightness icon in the upper-right corner of the Graffiti 2 writing area.
TIP
You can also press and hold the power button for about two seconds to
access brightness control. In addition, you can assign the full-screen pen stroke
to access the brightness control. See “Pen Preferences” in Chapter 16 for
details.
2. Drag the slider to adjust the brightness.
TIP
You can also press Up or Down on the navigator to adjust the brightness.
3. Tap Do n e.
Stylus
Slides in and out of the slot on the top of your handheld. To
use the stylus, slide it out of the slot and hold it as you would
a pen or pencil.
Power button/
brightness control
Turns your handheld on or off and enables you to access the
brightness control. If your handheld is turned off, pressing
the power button turns the handheld on and returns you to
the last screen you viewed.
If your handheld is turned on, you can turn it off by pressing
the power button. Pressing and holding the power button for
about two seconds opens the brightness control dialog box.
See the next section, “Using the backlight” for information
on adjusting the backlight.
To Next Page
Loading...
