Beaming problems
245
Beaming problems
Recharging problems
Problem Solution
I cannot beam data to another
device with an IR port.
Try each of these in turn:
■ If you are beaming to another Palm handheld, confirm that
your handheld and the other handheld are between ten
centimeters (approximately 4") and one meter
(approximately 39") apart and that the path between the
two handhelds is clear of obstacles. Beaming distance to
other devices with an IR port may be different.
■ Move your handheld closer to the receiving device.
■ Make sure the receiving device has enabled beam receive.
When someone beams data to
my handheld, I get a message
telling me it is out of memory.
Try each of these in turn:
■ Your handheld requires at least twice the amount of
memory available as the data you are receiving. For
example, if you are receiving a 30KB application, you must
have at least 60KB free.
■ Perform a soft reset. See “Performing a soft reset” in
Appendix A for more information.
Problem Solution
When I connect my handheld
to the cradle/cable, it does not
charge.
Try each of these in turn:
■ Confirm that your handheld is firmly connected to the
cradle/cable.
■ Confirm that your recharger cable is properly connected to
the cradle/cable. On some cradles/cables the recharger
cable connects to the back of the USB or serial port
connector that plugs into your computer, and on other
cradles/cables the recharger cable connects to the back of
the cradle/cable.
■ Confirm that your recharger is plugged into an AC outlet
that has power.
■ With your handheld seated in the cradle/cable. Press the
power button and tap the Home icon . Confirm that there
is a lightening bolt on the battery icon at the top of the
screen.
■ Charge your handheld for at least two full hours.
To Next Page
Loading...
