136
Maintenance and Inspections : Warning System
The following error codes are displayed in the display window if an error occurs in the camera:
If an error code is displayed, contact the dealer from which you purchased the unit.
Error Codes
Code No. Description
E-11 Video initialisation error
E-27 Recording control error
E-30 P2 card removal error
E-34 LCD microcontroller error
E-38 P2 streaming microcontroller error
E-3F Microprocessor error in the camera control
circuit.
E-63 Something is wrong with the system control
microprocessor.
E-6F Reference signal error.
1394 Error Codes
Code No. Description Recording
Indication in display
window
1394 E-80
Signals being input to the DVCPRO/DV
connector are not 1x speed transfer signals in
DV format.
Stops
The time code section of the
display window indicates the
appropriate error code that
blinks every two seconds.
1394 E-81
Signals being input to the DVCPRO/DV
connector are not 1x speed transfer signals in
DVCPRO (25 Mbps) format.
Stops
1394 E-82
Signals being input to the DVCPRO/DV
connector are not 1x speed transfer signals in
DVCPRO50 (50 Mbps) format.
Stops
1394 E-83
Incorrect signals are being input to the
DVCPRO/DV connector.
Stops
1394 E-84
Signals being input to the DVCPRO/DV
connector are not in DVCPRO or DV format.
Stops
1394 E-85
Signals being input to the DVCPRO/DV
connector are not 1x speed transfer signals in
DVCPR HD format.
Stops
1394 E-87
Incorrect audio signals are being input to the
DVCPRO/DV connector.
Continues with no sound.
1394 E-90
No signal is supplied to the DVCPRO/DV
connector.
While the recording mode
continues, no data is recorded on
cards unless the abnormal
condition is corrected. If an error
has occurred before recording,
then, recording does not start.
1394 E-91
With the menu option REC MODE set to DV,
copy guard information signals for recording
prohibited data are being input to the
DVCPRO/DV connector.
Stops
1394 E-92
The DVCPRO/DV connector is not properly
connected. The viewfinder indicates the
message "1394 INITIAL ERROR."
No recording in 1394 input mode
can be performed.
AJ-HPX2100E(English).book 136 ページ ２００６年１１月２７日 月曜日 午後４時３４分
To Next Page
Loading...
