28
Recording and Playback：P2 Cards
Note
When using the camera-recorder for the first time, be sure
to set the time data beforehand. On how the time data is
set, see [Setting Time Data] (page 48).
1 Turn on the POWER switch.
2 While pressing down the slide lock button, slide the
slide-out door to the left.
The door opens.
3 Insert a P2 card into the P2 card slot until the EJECT
button pops up.
4 Tilt up the popped-up EJECT button, to lock-in the P2
card.
5 Insert a P2 card into camera-recorder. The P2 CARD
ACCESS LED for the appropriate slot indicates the
status of the P2 card.
For how the P2 card status is indicated, see [P2
CARD ACCESS LED and status of P2 cards] (page
page 29).
6 Close the slide-out door.
Note
Do not leave the slide-out door open when moving
camera-recorder.
Inserting P2 Cards
POWER: ON
Slide lock
button
Slide-out door
EJECT button
The card must be
inserted with the
logo right way
up.
P2 CARD
ACCESS
LED
Recording and Playback
P2 Cards
AJ-HPX2100E(English).book 28 ページ ２００６年１１月２７日 月曜日 午後４時３４分
To Next Page
Loading...
