Panasonic AJ-HPX2100E - Handling Sd Memory Cards

75
Adjustments and Settings for Recording : Handling data
Adjustments and Settings for Recording
An SD memory card may be inserted or removed, either before or after the power is turned on.
Open the lid of the switch cover, and insert an SD memory
card (optional accessory) into the SD memory card slot
with the notch upward. Close the lid.
Note
An SD memory card must be inserted with the right side
facing the slot. If the card is hard to insert, it may be
reversed or upside down. Do not force it into the slot.
Check the card before re-inserting it.
Open the lid of the switch cover, and ensure that the BUSY
lamp is not illuminated. Then, further depress the SD
memory card towards the main unit. This releases the SD
memory card from the insertion slot. Take hold of the SD
memory card and remove it. Close the lid.
SD memory cards must not be used or stored in an
environment where they may be
z Exposed to high temperatures/humidities;
z Exposed to water droplets; or
z Electrically charged.
For storage, the SD memory card must be kept inserted
into the unit with the lid closed.
To format an SD memory card, write settings data or read
data on an SD memory card, navigate the menu to the
<SD CARD READ/ WRITE> screen from the FILE page.
For an SD memory card formatted with a device that does
not support SD standards, the message “FORMAT
ERROR” appears at the upper right of the screen. In this
case, reformat the card as follows. Note that the indication
“FORMAT ERROR” does not disappear if the SD memory
card is replaced with this menu page open. When the SD
memory card is replaced, perform TITLE READ.
Note
SD memory cards may be formatted via the thumbnail
screen. For more information, see [Formatting SD memory
cards] (page 113).
1 Navigate the menu to the <SD CARD READ/WRITE>
screen.
2 Turn the JOG dial button to move the cursor to the
menu option CARD CONFIG.
3 Press the JOG dial button to display the following
message:
Handling SD memory cards
To insert an SD memory card To remove the SD memory card
Formatting, Writing and Reading an SD memory card
# < SD CARD READ/WRITE >
R.SELECT :1
READ
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
To format an SD memory card
CONFIG?
YES
# NO
AJ-HPX2100E(English).book 75 ページ ２００６年１１月２７日 月曜日 午後４時３４分