88
Preparation：Power Supply
A battery pack or an external DC power supply can be used as AJ-HPX2100’s power supply.
Battery packs from the following manufacturers can be
used:
• Anton/Bauer
• IDX
• PAC O
• Sony
The type of the battery can be checked or changed
through the viewfinder or menu screen on the monitor.
z Pressing the MODE CHECK button on the side of the
camera-recorder displays the current type of the battery
in the upper right corner of the viewfinder display.
z Navigate the menu to open the BATTERY/P2CARD
screen from the MAIN OPERATION page. Then, through
the BATTERY SELECT menu option, you can check and
change the battery type.
Notes
z Other batteries may be used by changing the menu
setting, but system compatibility is not guaranteed.
z Charge the battery pack with the battery charger before
using it. (Please refer to the battery charger’s instruction
manual for information about charging.)
Using a Battery Pack
#
< BATTERY/P2CARD >
BATTERY SELECT :PRO14
EXT DC IN SELECT :AC-ADPT
BATT NEAR END ALARM :OFF
BATT NEAR END CANCEL:ON
BATT END ALARM :ON
BATT REMAIN FULL :70%
CARD NEAR END ALARM :ON
CARD NEAR END TIME :2min
CARD END ALARM :ON
CARD REMAIN/
:3min/
Preparation
Power Supply
AJ-HPX2100E(English).book 88 ページ ２００６年１１月２７日 月曜日 午後４時３４分
To Next Page
Loading...
