90
Preparation：Power Supply
1 Remove the battery holder.
2 Mount the NP-1 type battery case on the camera-
recorder.
1Tighten the mounting screws.
2Tighten the power contact screws.
3Insert the upper part of the removed cover in the
direction of the arrow.
4Align the holes in the bottom part (metal part) of the
cover with the holes in the case, and secure the
cover with the screw.
Note
When mounting the battery holder, take care not to
pinch the connection cord.
When using a V-mount type battery pack
Mount the V-mount adapter plate.
Insert the plate and slide it in the direction of the
arrow.
3 Setting the battery type.
Select the battery type listed under BATTERY
SELECT. Select BATTERY SELECT from the
<BATTERY/P2CARD> screen on the MAIN
OPERATION page.
When using another battery which cannot be selected
using the BATTERY SELECT item setting, select
TYPE A or TYPE B, and set the items that correspond
to the characteristics of the battery.
Please refer to [BATTERY SETTING2] (page 165) for
more information.
Note
For information about the V-mount adapter plate,
please contact the store where you purchased the
camera-recorder.
Using an NP-1 type battery pack
CAUTION:
These servicing instructions are for use by qualified
service personnel only. To reduce the risk of fire or
electric shock do not perform any servicing other than
that contained in the operating instructions unless you
are qualified to do so.
Battery Case (for NP-1 type)
AJ-HPX2100E(English).book 90 ページ ２００６年１１月２７日 月曜日 午後４時３４分
To Next Page
Loading...
