Panasonic AW-HE60 - Connections; Connections with an HD Monitor; Example of an IP Connection (When Connecting the AW-HE60 S and AW-RP50 in a One-To-One Configuration)

19
Installation
Instructions
Connections
Connections with an HD monitor
HD monitor
HDMI signal (AW-HE60H only), SDI signal (AW-HE60S only) or
HD analog component signal
HD Integrated Camera
AW-HE60
Wireless remote controller (optional accessory)
Up to four units can be operated using one remote control.
Example of an IP connection (when connecting the AW-HE60S and
AW-RP50 in a one-to-one configuration)
SIGNAL GND
TALLY/GPI
TO PAN/TILT HEAD
5 4 3 2 1
SV
POWER
ON
BOOT
NM
12V IN
LAN
Remote camera control signals
HD Integrated Camera
AW-HE60S
Remote Camera Controller
AW-RP50
Accessory AC adaptor Accessory AC adaptor
LAN cable
(crossover cable)
Monitor
 Use a crossover cable for the LAN cable.

Using the connection settings of the AW-RP50, set the unit and remote camera connection to the IP connection [Network] for
camera number CAM1.
1. Select [SYSTEM] menu  [CAMERA CTL], and display [CAM1].
2. Set the camera number to [Network].
1 . C A M 1
N e t w o r k