20
Connections
(continued)
Connections with a controller (AW-RP655 or AW-RP555)
Y
PB
PR
V
IN
OUT
LAN cable (straight cable)
Pan-tilt head/
camera control signals
HD Integrated Camera
AW-HE60
Multi Hybrid
Control Panel
AW-RP555
HDMI/SDI video signal
AC Adapter
AW-PS550
Accessory AC adaptor
Monitor
Multi-Function Controller
AW-RP655
AC Adapter
AW-PS550
Multi-Interface
Cable
AW-CA20T6G
RJ-45 relay
adapter
Precautions when using the AW-RP655 or AW-RP555 controller
Before connecting a model AW-RP655 or AW-RP555 controller that was manufactured prior to June 2010 to the
AW-HE60H or AW-HE60S camera and using it to control the camera, the firmware of the controller must be updated.
For details, consult your dealer.
Note
Multi-Interface Cable AW-CA20T6G
Y
PB
PR
V
IN
OUT
HD/SD component output x 1,
VBS output x 1
RS-422 interface
Use of this cable makes it possible for the component and VBS signals to be output at the same time as the output of the
HDMI (AW-HE60H) or SDI (AW-HE60S) signals.
* IP video is enabled in the factory default setting and VBS cannot be output.
(IP video cannot be output simultaneously with VBS.)
To switch to VBS output, open the AW-HE60 web screen on a personal computer to make the required changes to the
settings.
For details, refer to [Controls and settings from web screen] [Setup screen] [IP video settings (Video over IP)]
(page 66 in the <Operations and Settings>).page 66 in the <Operations and Settings>).in the <Operations and Settings>).
To Next Page
Loading...
