Panasonic AW-UE100WP

Electronic shutter speed:
• 59.94p/59.94i mode
1/60, 1/100, 1/120, 1/250, 1/500, 1/1000, 1/2000,
1/4000, 1/8000, 1/10000
• 29.97p mode
1/30, 1/60, 1/100, 1/120, 1/250, 1/500, 1/1000,
1/2000, 1/4000, 1/8000, 1/10000
• 23.98p/24p mode
1/24, 1/48, 1/60, 1/100, 1/120, 1/250, 1/500,
1/1000, 1/2000, 1/4000, 1/8000, 1/10000
• 50p/50i mode
1/60, 1/100, 1/120, 1/250, 1/500, 1/1000, 1/2000,
1/4000, 1/8000, 1/10000
• 25p mode
1/25, 1/50, 1/60, 1/100, 1/120, 1/250, 1/500,
1/1000, 1/2000, 1/4000, 1/8000, 1/10000
Synchro scan:
• 59.94p/59.94i mode
60.00 Hz to 7200 Hz
• 29.97p mode
30.00 Hz to 7200 Hz
• 23.98p/24p mode
24.00 Hz to 7200 Hz
• 50p/50i mode
50.00 Hz to 7200 Hz
• 25p mode
25.00 Hz to 7200 Hz
Gamma: HD/FILMLIKE1/FILMLIKE2/FILMLIKE3
White balance: ATW, 3200K, 5600K
AWB: AWB-A/AWB-B
VAR (selectable between 2000K and 15000K by
designating a value)
Chroma amount variability:
OFF, –99% to 99%
Scene file: Scene1, Scene2, Scene3, Scene4
Output format
SDI output:
[4K format] 2160/59.94p, 2160/50p, 2160/29.97p
*
1
, 2160/25p
*
1
,
2160/24p
*
1
, 2160/23.98p
*
1
[HD format] 1080/59.94p, 1080/50p, 1080/29.97p
*
1
,
1080/29.97PsF, 1080/25p
*
1
, 1080/25PsF,
1080/23.98p
*
2
, 1080/24p
*
1
, 1080/23.98p
*
1
,
1080/23.98PsF, 1080/59.94i, 1080/50i, 720/59.94p,
720/50p
HDMI output:
[4K format] 2160/59.94p, 2160/50p, 2160/29.97p
*
1
, 2160/25p
*
1
,
2160/24p
*
1
, 2160/23.98p
*
1
[HD format] 1080/59.94p, 1080/50p, 1080/29.97p
*
1
, 1080/25p
*
1
,
1080/23.98p
*
3
, 1080/24p
*
1
, 1080/23.98p
*
1
,
1080/59.94i, 1080/50i, 720/59.94p, 720/50p
*
1
Native output
*
2
OVER 59.94i output (your monitor may recognize the signal as
59.94i).
*
3
OVER 59.94p output (your monitor may recognize the signal as
59.94p).
Synchronization system:
Internal/External synchronization (BBS/Tri-level sync)
[Pan‑tilt head unit]
Installation method:
Stand-alone (Desktop) or suspended (Hanging)
• To ensure safety, the unit must be secured using
the mount bracket supplied.
Camera/pan‑tilt head control:
IP connecting
cable
• When connecting through a PoE++ hub
LAN cable
*
4
(category 5e or above, straight
cable), max. 100 m (328 ft)
• When a PoE++ hub is not used
LAN cable
*
4
(category 5e or above, straight
cable), max. 100 m (328 ft)
AW protocol
connecting cable
LAN cable
*
4
(category 5e or above, straight
cable), max. 1000 m (3280 ft)
*
4
Use of an STP (shielded twisted pair) cable is recommended.
Pan/tilt operation speed:
Speed range: 0.08°/s to 60°/s (Normal mode)
*
3 speed modes installed
Normal: 60°/s, Fast1: 90°/s, Fast2: 180°/s
• Note that the operating noise may be loud in high
speed.
• If the operating noise is disturbing, use the Normal
mode.
Panning range : ±175°
Tilting range : –30° to 210°
• Depending on the pan or tilt position, the camera
may be reflected in the image.
Quietness: NC35 or less

AC adaptor
Input: 100 V to 240 V AC ( ), 50/60 Hz, 1.2 A
Output: 12 V DC (
), 3.0 A, 36 W
indicates safety information.
Inrush current, measured according to European standard EN55103-1,
on initial switch-on: 4.5 A, after a supply interruption of 5 s: 16 A
174 175
Specifications (continued)