28
Setup Utility
<Only when the port replicator is connected>
Running the Setup Utility
Setup Utility can be run only when the port replicator, external display and external
keyboard are connected.
NOTE
1 Power off your computer ( "Starting Up/Shutting Down")
Do not shut down using the standby or hibernation mode.
2 Connect your computer to the port replicator, external display,
external keyboard and external mouse
( Operating Instructions of the port replicator, page 21)
3 Turn on the computer
4 Press F2 while [Panasonic] boot screen is displayed soon
after the computer begins the startup procedure
If [Enter Password] is displayed, enter your password.
When a User Password is entered, some contents cannot be changed ( page 7).
If you fail to press F2 at the right moment, the Setup Utility will not start up. In
this case, power off the computer and try again.
To close the Setup Utility, press Esc , select the exiting method in [Exit] menu,
then press Enter .
NOTE
F1 :To display the corresponding “help” file.
Esc :To display [Exit] menu.
:To move among the items.
:To move among the menus.
F5 F6 :To move among the values.
Enter :To display sub-menu of each item selected by .
F9 :To set default settings (except the password).
(When starting up the Setup Utility with the User Password, this key
is not available.)
F10 :To save the settings and exit.
Key Operations
When setting date and time, Tab can be used to move the cursor.
NOTE
To Next Page
Loading...
Need help?
General