21
Security Measures
NOTE
z When the Supervisor Password has not been set, the User Password can not be set.
Set the Supervisor Password if you have not done so. (Î page 19)
z To disable the User Password, start up the Setup Utility with the Supervisor Password.
1 Run the Setup Utility. (Î page 81)
2 Using either Î or Í, select [Security].
3 Using either Ï or Ð, select [Set User Password] and press
Enter
.
4 Only when the User Password has been set:
Enter your password at [Enter Current Password] and press
Enter
.
5 Enter your password at [Enter New Password] and press
Enter
.
z To disable the User Password
Press only
Enter
.
6 Re-enter your password at [Confirm New Password] and press
Enter
.
z To disable the User Password
Press only
Enter
.
7 At [Setup Notice], press
Enter
.
8 Press
F10
and select [Yes], then press
Enter
.
CAUTION
z Do not forget your password. If a password is forgotten, you will be unable to use your
computer. If this happens, ask a person who knows the Supervisor Password.
z When running the Setup Utility, do not leave your computer even for a short time, as
the possibility exists for the password to be set/changed by another person.
Setting the User Password (enabling, changing, disabling)
To Next Page
Loading...
