59
RAM Module
3 Insert/Remove RAM module.
z Inserting the RAM module
A Slide in the module at an angle.
B Press the RAM module down until the right and left hooks (A) lock into place.
z Removing the RAM module
A Gently open the right and left hooks (A).
The RAM module will be raised at an angle.
B Gently remove the RAM module from the slot.
4 Put the cover back in place.
A Insert the cover at an angle, then fit it into place.
B Fasten the screw.
5 Insert the battery pack. (Î page 34)
NOTE
z Whether the RAM module is properly recognized or not can be confirmed in
[Information] menu of the Setup Utility (Î page 83).
If the RAM module is not recognized, power off the computer and insert it again.
To Next Page
Loading...
