Panasonic CF-M34 Series Toughbook - External Display

30
External Display
1
Connect the external display to the port replicator
Power off your computer ( “Starting Up/Shutting Down”)
Do not shut down using the standby or hibernation function.
3
Connect your computer to the optional port replicator
( The operation manual of the port replicator, page 29)
2
External Display Port
Port Replicator
4 Turn on the external display, then turn on your computer
It is possible to change the display destination with Fn + F3 or in the following
menu.
Windows 2000 :[Start] - [Settings] - [Control Panel] - [Intel
®
Graphics Technology] -
[Devices]
Windows XP :[Start] - [Control Panel] - [Other Control Panel Options] - [Intel
®
Graphics Technology] - [Devices]
The screen is not displayed based on the [Display] setting in the Setup Utility.
This combination does not work when the [Command Prompt] screen is set
to “Full Screen” or MPEG files are open.
Windows 2000
The display can be changed by pressing Fn + F3 twice even if MPEG files
are open.
The screen that is displayed when resuming from the hibernation mode may be
different from the screen that is displayed before entering the hibernation mode.
When you change the display destination after Windows starts up, do not press
any keys or the power switch until the destination has changed completely.
After the display destination of the screen is switched with Fn + F3 , the
resolution or number of colors of the display may change.
About [Intel
®
Graphics Technology]
The selection of the display destination, adjustment of the brightness and
contrast, and setting of the hotkey to change the display destination can be
done in the following menu.
NOTE
NOTE
CAUTION
Do not switch displays repeatedly using the Fn + F3 combination.
5 <When a monitor that does not conform to the Plug & Play standards
is connected>
Windows 2000
Select [Control Panel] - [Display] - [Settings] - [Advanced] - [Monitor] - [Properties]
- [Driver] - [Update Driver] and make the monitor settings.
Windows XP
Select [Control Panel] - [Appearance and Themes] - [Display] - [Settings] - [Advanced]
- [Monitor] - [Properties] - [Driver] - [Update Driver] and make the monitor settings.
For more detailed information, refer to the operation manual of the external display.