EasyManua.ls Logo

Panasonic CF-M34 Series Toughbook - Technical Information

Panasonic CF-M34 Series Toughbook
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
44
Technical Information
Network
When the power saving function is running, communications software may malfunction.
For example, communications may be halted if the standby (hibernation) mode is acti-
vated. The computer must be restarted if one of these modes is entered during data
communications.
Be sure that the power of the display is cut (for energy conservation purposes) or the
computer enters standby (hibernation) mode after the communications software is closed.
Windows 2000
When network or communication software is to be used, set [Turn off monitor], [Turn off
hard disks], [System standby] and [System hibernates] (in [Start] - [Settings] - [Control
Panel] - [Power Options]) to [Never].
Windows XP
When network or communication software is to be used, set [Turn off monitor], [Turn off
hard disks], [System standby] and [System hibernates] (in [Start] - [Control Panel] -
[Performance and Maintenance] - [Power Options]) to [Never].
Windows Security Function
Windows has a security function that differs from the security function of the Setup
Utility. For detailed information, refer to the Windows help.
Set the password for secrecy and protection.
Only an account for the Administrator is created the first time the computer is
started. Create accounts for person or persons who are actually going to use a
computer.
We recommend using an NTFS file system in order to use the Windows security
function.
NOTE
Precautions When Using a CardBus Type LAN Card
Prior to usage, optimize the LAN card settings by following the procedure given below. Failure to do so may result in
an error message being displayed when performing a copy operation via the LAN card with a computer on the
network.
1 Double-click the Network Card you are using from [Network adapters] in [Control Panel] - [System] - [Hardware] -
[Device Manager]
2 Select [Advanced], select [Store And Forward] from [Property], then set [Enabled] for [Value] if it is set to [Disabled]
(This item may be unavailable for some types of network cards.)
Windows 2000

Related product manuals