30
Security Measures
Use these features to protect your data.
z Another security measure
• Embedded Security (TPM) (Î page 92): For further information, refer to the Installation Manual of “Trusted Platform
Module (TPM)”.
Set the Supervisor Password before setting the User Password.
1 Start up the Setup Utility (Î page 86).
2 Select [Security].
3 Select [Set Supervisor Password] or [Set User Password], and press (Enter).
4 Enter your password in [Create New Password] and press (Enter).
z When the password has been set, you need to enter your password in [Enter Current Password] and press
(Enter).
z To disable the password, leave the input field empty and press (Enter).
5 Enter your password again in [Confirm New Password] and press (Enter).
6 Press
Fn
+
B
(F10)
*1
, and then select [Yes] and press (Enter).
*1
For Numeric keyboard model, connect a USB keyboard and press
F10
.
CAUTION
z Do not forget your password. If you forget your Supervisor Password, you will not be able to use your computer. Con-
tact Panasonic Technical Support.
z When running the Setup Utility, do not leave and go away from your computer even for a short time, since other people
may set or change the password.
NOTE
z The password will not be displayed on the screen.
z You can use up to 32 alphanumeric characters (including spaces).
• The case (upper/lower) is ignored.
• Use only the upper horizontal row of numeric keys to input your password.
• You cannot use (Shift) and
Ctrl
to input a password.
z Disabling the Supervisor Password also disables the User Password.
Setting the Supervisor Password/User Password
To Next Page
Loading...
