51
4 To enter zone 2 area: (Press continuously for T ≥ 5 secs)
5 Function & Options list:
Note: The functions described in the table may not be applicable to the model and may subject to change
without further notice.
Function Options Remark
No Name
Zone 1
1 Remote control number selection A, B, C, D
2 Solar radiation sensitivity level adjustment 1, 2, 3, 4, 5
3
[iAUTO-X/iAUTO/iCOMF, Cool & Dry] mode set temperature [Low2]
selection
16°C ~ [High2]
4
[iAUTO-X/iAUTO/iCOMF, Cool & Dry] mode set temperature [High2]
selection
[Low2] ~ 30°C
5 Heat mode set temperature Low1 selection 16°C ~ [High1]
6 Heat mode set temperature High1 selection [Low1] ~ 30°C
7 Filter cleaning disable/enable selection 00 / 01
8 nanoe-G default ON disable/enable selection 00 / 01
9 Dust sensor monitoring & LED disable/enable selection 00 / 01
10 Auto restart disable/enable selection 00 / 01
11 Dust sensor sensitivity level adjustment 1, 2, 3
12 ~ 49 Reserve
Zone 2
50 ECO demo ON None (No display)
51 Light sensor check None (No display)
52 nanoe-G / ECO sensor check None (No display)
53 DOA check None (No display)
54 Odor cut control selection [Enable (01) / Disable (00)] 00 / 01
55 Frequency tolerance selection [±3Hz (03) / ±7Hz (07)] 03 / 07
56
Fixed fan speed selection during heat mode compressor OFF
[Enable (01) / Disable (00)]
00/01
57 nanoe check None (No display)
58 Heat mode thermo shift adjustment -3°C ~ 3°C
59 Others (Cool & Dry) mode thermo shift adjustment -3°C ~ 3°C
60
Deice start determination judgment temperature switching [Yes (01) /
No (00)]
00/01
61 Cool mode disable selection [Yes (01) / No (00)] 00/01
62 Heat mode disable selection [Yes (01) / No (00)] 00/01
63 Base pan heater selection [Base pan A (A) / Base pan B (b)] A / b
64
Disable fan speed reduction during cool mode thermo-Off [Yes (01) /
No (00)]
00/01
65 LED smart OFF selection
00 – Disable /
01 – Enable
66 nanoe-g ON/OFF duration selection
01 – Pattern 1 /
02 – Pattern 2 /
03 – Pattern 3 /
04 – Pattern 4
67 Operation OFF deice function selection
00 – Disable /
01 – Enable
68 Compressor frequency change speed selection
01 – Pattern 1 /
02 – Pattern 2 /
03 – Pattern 3
69 ~ 99 Reserve
Once T ≥ 5secs
Enter Zone2
[range (50~99)]
Enter Zone1Normal display
mode
To Next Page
Loading...
