Panasonic CS-S18PKH

130
6. Detach the CN-DISP
connector then remove
the indicator complete.
7. Detach the HV+ (White) &
HV- (Black) terminal
wires, CN1 and GND then
remove the high voltage
generator.
10. Detach 6 connectors as labeled
f
rom
the electronic controller. Then pull out
main controller gently
11. Detach AC303 (WHT), RY-PWR connector
(Black and Brown) from the electronic controller.
12. Detach AC304 (RED) from Terminal Board.
CN-STM2
CN-STM1
9. Pull out the main
electronic controller
controller halfway.
8. Remove screw to
remove terminal board
complete.
5. Detach the Earth wire
CN-MSENS
CN-TH
CN-CLN
CN-FM
AC303 (WHT
)
RY-PWR
AC304 (RED)
Figure 3 Figure 4
16.1.1.3 To remove discharge grille
13. Pull out to remove the drain hose
from the discharge grille
14. Then pull the discharge grille
downward gently to dismantle it
Figure 5