136
18. Remove the bearing by pulling it
out gently
17. Remove the screw from the
evaporator.
Figure 19
19. Push the holdfast to the left and lift up the evaporator.
21. Fan motor can be removed after the
removal of cross flow fan.
Reminder: To reinstall the fan motor, adjust
the fan motor connector to 45° towards you
before fixing control board.
20. Remove the cross flow fan from
the unit by pulling it to the left and
downward.
Evaporator
Figure 20
Reminder: To reinstall the cross flow
fan, ensure cross flow fan is in line as
shown in figure 21.
Cross Flow Fan
Figure 21
To Next Page
Loading...
