80
14.10 Quiet Operation (Heating)
A. Purpose
To provide quiet heating operation compare to normal operation.
B. Control condition
a. Quiet operation start condition
o When “POWERFUL/QUIET” button at remote control is pressed.
b. Quiet operation stop condition
1 When one of the following conditions is satisfied, quiet operation stops:
a. POWERFUL/QUIET button is pressed again.
b. Stop by OFF/ON switch.
c. Timer “off” activates.
2 When quiet operation is stopped, operation is shifted to normal operation with previous setting.
3 When fan speed is changed, quiet operation is shifted to quiet operation of the new fan speed.
4 When operation mode is changed, quiet operation is shifted to quiet operation of the new mode.
5 During quiet operation, if timer “on” activates, quiet operation maintains.
6 After off, when on back, quiet operation is not memorized.
C. Control contents
a. Fan Speed manual
1 Fan speed is changed from normal setting to quiet setting of respective fan speed.
2 Fan speed for quiet operation is reduced from setting fan speed.
b. Fan Speed Auto
1 Indoor FM RPM depends on pipe temp sensor of indoor heat exchanger.
14.11 Powerful Mode Operation
When the powerful mode is selected, the internal setting temperature will shift lower up to 2°C (for Cooling/Soft
Dry) or higher up to 3.5°C (for Heating) than remote control setting temperature for 20 minutes to achieve the
setting temperature quickly.
www.ampair.co.uk | sales@ampair.co.uk
To Next Page
Loading...
Need help?
General
