89
4 REMOTE CONTROL RECEIVING SOUND OFF/ON MODE
The Remote Control Receiving Sound OFF/ON Mode will be activated if the Auto OFF/ON button is pressed
continuously for more than 16 seconds (4 “beep” sounds will occur at 16th seconds to identify the Remote
Control Receiving Sound Off/On Mode is in standby condition) and press “AC Reset” button at remote
control.
Press “Auto OFF/ON button” to toggle remote control receiving sound.
o Short “beep”: Turn OFF remote control receiving sound.
o Long “beep”: Turn ON remote control receiving sound.
After Auto OFF/ON Button is pressed, the 20 seconds counter for Remote Control Receiving Sound OFF/ON
Mode is restarted.
17.2 Heat Only Operation
17.2.1 How to Activate/Deactivate Heat only Operation
AUTO SW
is pressed
Emergency
Operation
Forced
Cooling
Operation
Forced
Cooling
Operation
Forced
Heating
Operation
Remote
Control
Number
Switch
Mode
Remote
Control
Receiving
Sound
OFF/ON
*Operation
Time Check
Mode
No
Setting
Mode
Heat Only
Mode
Enable/
Disable
AC reset code AC reset code AC reset code AC reset codeAC reset code CHECK
code
Beep
5s 8s 11s 16s 21s 26s 36s
BeepBeep BeepBeepBeep BeepBeepBeepBeep Beep No
The unit will operate under forced cooling
mode continuously if “AC reset” code is
not pressed to activate standby
To enable the “Heat Only” mode, press the AUTO OFF/ON SW for more than 8s and less than 11s, “Beep Beep”
sound will be heard, then release the AUTO OFF/ON SW and press remote controller CHECK button. A short
“Beep” sound will be heard. “Heat Only” mode is now enable.
To disable the “Heat Only” mode, press the AUTO OFF/ON SW for more than 8s and less than 11s, “Beep Beep”
sound will be heard, then release the AUTO OFF/ON SW and press remote controller CHECK button. A long
“Beep” sound will be heard. “Heat Only” mode is now disable.
To pump down the unit during Heat Only Operation press AUTO switch for 5 seconds.
www.ampair.co.uk | sales@ampair.co.uk
To Next Page
Loading...
Need help?
General
