Panasonic CS-TZ25ZKEW

76
12.4.8 Auto Switch Operation
The below operations will be performed by pressing the “AUTO” switch.
1 AUTO OPERATION MODE
The Auto operation will be activated immediately once the Auto
Switch is pressed and release within 5 sec..
2 TEST RUN OPERATION (FOR PUMP DOWN/SERVICING
PURPOSE)
The Test Run operation will be activated if the Auto Switch is
pressed continuously for more than 5 sec. to below 8 sec..
A “pep” sound will occur at the fifth sec., in order to identify the
starting of Test Run operation.
3 HEATING TRIAL OPERATION
Press the “AUTO” switch continuously for more than 8 sec. to below 11 sec. and release when a “pep pep”
sound is occurred at eight sec. (However, a “pep” sound is occurred at fifth sec..) Then press Remote
controller “AC Reset” button once.
Remote controller signal will activate operation to force heating mode.
4 REMOTE CONTROLLER RECEIVING SOUND ON/OFF
The ON/OFF of Remote controller receiving sound can be change over by the following steps:
o Press “AUTO” switch continuously for more than 16 sec. to below 21 sec..
A “pep”, “pep”, “pep”, “pep” sound will occur at the sixteenth sec..
o Press the “AC Reset” button once, “pep” sound will occur indicates that Remote controller receiving
sound setting mode is activated.
o Press “AUTO” switch again. Everytime “AUTO” switch is pressed (within 60 sec. interval), Remote
controller receiving sound status will be reversed between ON and OFF.
Long “peep” sound indicates that Remote controller receiving sound is ON.
Short “pep” sound indicates that Remote controller receiving sound is OFF.
12.4.9 Heating Only Operation
1 Use remote controller to set heating only operation. When the unit in standby mode, follow the steps below:
o Press continuously for more than 5 seconds to enter special setting mode.
o Press to choose function 61, and then press to set “01”.
o Press to activate “Heating only operation”.
12.4.10 How to Replace Network Adapter
1. Remove the front grille (refer how to take out front grille) from the unit.
2. Remove 1 mounting screw, then remove the network adaptor holder.
3. After that, network adaptor can be easily replaced.
12.4.11 Check the Drainage
 Open front panel and remove air filters.
(Drainage checking can be carried out without
removing the front grille.)
 Pour a glass of water into the drain tray-styrofoam.
 Ensure that water flows out from drain hose of the
indoor unit.
SET
Activate or deactivate
“Heating only
operation”
Special setting mode
(Function
no.)
(Options)
T
>
5 secs
32
Network adaptor
holder
Screw
Drain tray-styrofoam