– 18 –
ENGLISH
If the CHECK display on the wired remote control display is flashing
Stop the indoor unit and check the conditions. After three minutes, start the operation again.
■ If the display still flashing
Display
A/C No.
• The air conditioner No. “01” appears during normal
installation and use. When using group control, a different
number may appear.
Press the CHECK button.
The timer display will change.
F15 ~ F49 will appear in place of the time. (The temperature
setting display will also change to show the air conditioner
number.)
(Example)
Please engage an authorized dealer for the malfunction
details.
AIR
MANUALLOCAL
TIMER
TEMP
MED
COOL
FAN
SPEED
OPE-
RATION
SWING
CHECK
Symptom
Indoor unit does not operate when a
button is pressed.
The unit does not cool or heat
properly.
Cause
• Is the remote control out of range of
the indoor unit’s ray receiver?
• Does the address number match with
the setting of the indoor unit’s ray
receiver ADDRESS SET switch?
• Check whether an appropriate
operation mode is selected?
• Is anything blocking the inlet or outlet
vents of indoor or outdoor unit?
• Is the air filter soiled or dusty?
• Check if doors or windows have been
opened and closed frequently, or
whether heat-operating equipment
such as gas stoves and irons are
being used in the same room.
If the wireless remote control display is illuminated
Reference
Page 10.
Page 15.
Refer to page 17 for proper use details.
Remove any obstacles.
Refer to page 16 for maintenance
details.
Refer to page 17 for proper use details.
AIR
AIR
TIMER
FAN
SPEED
OPE-
RATION
TEMP
UP
DOWN
FILTER
SELECT
SET
AUTO
MANUAL
TEST RUN
CLOCK
CANCEL
A/C No.CHECK
MANUALLOCAL
CZ-RD51P
TIMER
TEMP
MED
COOL
FAN
SPEED
OPE-
RATION
SWING
RESET
SWING
OFF
/
ON
CHECK
To Next Page
Loading...
Need help?
General
