Panasonic CS-Z20VKEW

168
Searching for air-condi oner.
Please wait…
Connection Guide
Step 1
Step 2
Step 3
Cancel
Select the air-condi oner for registra on
Unregistered air-condi
oner
Registered air-condi
oner
Retry searching…
Connection Guide
Step 1
Step 2
Step 3
Unknown air-conditioner
Retry searching…
Cancel Register
4. If the Wireless LAN LED keep blinking,
check the wireless router connection.
5. Select the air conditioner model to
register the device.
19.4.2.5 Connection Network Using AP Mode (Method 2)
If Wireless LAN LED is OFF during the connec on
setup, please enable again by pressing “Wireless
LAN” bu
on once before proceeding to step .
Press and hold “Wireless LAN” bu on for
5 secs un
l easy se .nwohs si ”1“ gn
Press “up” or “down” bu on un l Advance
se
ng “2” is shown.
Point remote control to air-condi oner
and press “SET” bu
on once.
A er step ~ have been done, tap“Next”.
Connection Guide
Step 1
Step 2
Step 3
Cancel
Next
SET
CANCEL
By changing the wireless network connec on of
smartphone to the following network.
SSID: Panasonic-CS-wirelessAP
Password: Rac8pswi
Connection Guide
Step 1
Step 2
Step 3
Cancel
To wireless network settings of the smartphone.To wireless network settings of the smartphone.
1. Ensure Wireless LAN LED is ON. Press and hold the Wireless LAN
button for 5 seconds
until “1” is shown on the remote control.
Press
until “2” is shown on the remote control and press
SET
pointing to the air conditioner.