- 16 -
Press the Power Button on the Remote Control to select the Serviceman Adjustment.
For Adjustments:
CH
CH
PW
IMPORTANT NOTE:
Always Exit the Serviceman
Mode Following Adjustments.
CH
CH
CH
CH
Sub-Data Adjustment Adj. Range
Default
Level
B0 SUB-COLOR 0 ~ 63 24
B1 SUB-TINT 0 ~ 63 45
B2 SUB-BRIGHTNESS 0 ~ 255 75
B3 SUB-PICTURE 0 ~ 63 31
B4 KILLER/ABL/GAMMA 0 ~ 7 5
B5 VIDEO ADJUSTMENT 0 ~ 15 8
B6 AUDIO ADJUSTMENT 0 ~ 31 16
B7 V-SIZE 0 ~ 63 37
Cut-Off Adjustment Adj. Range
Default
Level
C0 CUT-OFF R
0 ~ 1
0 ~ 255
0
127
C1 CUT-OFF G 0 ~ 255 64
C2 CUT-OFF B
0 ~ 1
0 ~ 255
0
100
C3 DRIVE R 0 ~ 127 67
C4 DRIVE B 0 ~ 127 64
C5 YNR SWITCH 0 ~ 1 0
C6 AFT
0 ~ 1
0 ~ 255
1
103
C7 RF-AGC 0 ~ 127 64
C8 YNR VIDEO ADJUSTMENT 0 ~ 7 0
C9 HORIZONTAL CENTER 0 ~ 31 12
Ca BEAM LIMIT 0 ~ 7 4
Cb VCJ TEST H 0 ~ 2 2
1.Press Channel Up/Down on the
Remote Control to select one of
the available Service Adjustments
(a in Fig. 13).
Note: Write Down the original
value set (b in Fig. 13) for
each address before
modifying anything. It is
easy to erroneously adjust
the wrong item.
2.Press Volume Up/Down on the
Remote Control to adjust the
level of the selected Service
Adjustment (b in Fig. 13).
To Next Page
Loading...
