71
RQT8849
Reference
No sound.
Low volume.
Distorted sound.
Cannot hear the desired
audio type.
Check the connections and the “Digital Audio Output” settings.
Check the input mode on the amplifier if you have connected one.
42, 52
Check if TV is muted.
−
Check if amplifier is muted.
−
Press [AUDIO] to select the audio.
20, 26
Sound is not output while fast-forwarding during chasing playback
and simultaneous record and playback.
−
Set “V. Surround Sound” in the Audio menu to “Off” in the following
cases:
– When using discs that do not have surround sound effects, such as
Karaoke discs
– When playing analog multi lingual broadcast recordings
35
The sound effects will not work when the bitstream signal is output
from the DIGITAL AUDIO OUT terminal.
−
Cannot switch audio.
You cannot change the audio type when a DVD-R, DVD-R DL,
DVD-RW (DVD-Video format), +R, +R DL, or +RW disc is in the disc
tray.
−
You cannot change the audio type when playing a recording of an
analog multi lingual broadcast on a DVD-R, DVD-R DL, DVD-RW
(DVD-Video format), +R, +R DL or +RW disc. You can select “Main”
or “Secondary Audio Program (SAP)” in “Multi-channel TV Sound
(Analog)” in the Setup menu before recording.
13, 15,
42
Only one language channel is recorded from digital multi lingual
broadcasts, so you will be unable to change languages during
playback.
15
You have used a digital connection. Set “Dolby Digital” to “PCM” or
connect using an audio cable (analog connection).
42, 52
There are discs whose audio cannot be changed due to how the
disc was created.
−
Playback Issues
Sound
Page
To Next Page
Loading...
