POWER
DVD/VHS
DRIVE
SELECT
to select the drive (DVD or VHS).
Insert a disc or VHS cassette.
– Insert a disc or VHS cassette with enough remaining blank space
( 65).
TRACKING/V-LOCK
CH
to select desired channel.
Antenna Mode: Cable TV Mode:
– To select with the numbered buttons ( 6).
– When no channel setting is performed on the unit and broadcast
is recorded directly from the cable box or satellite receiver,
select a channel on the connected equipment and press
[INPUT SELECT] to select “IN1” or “IN2”.
REC MODE
to select the recording mode.
Recording mode ( 14) Remaining time
REC
to start recording.
Recording Television Programs
Preparation:
Turn on the television and select the appropriate video input to suit the
connections to this unit.
[RAM] If the disc is protected, release protection ( 36).
[VHS] Ensure accidental erasure tab is intact.
Pausing Recording
Press [ PAUSE].
– Press again to restart recording.
Stopping Recording
Press [ STOP].
Refer to “Important Notes for Recording” ( 13) and “Advanced Recording”
( 14 to 17) for detail information on recording.
[RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW] [VHS]
Digital broadcasts cannot be recorded to video tape.
Notes
[-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW] It takes about 30 seconds for the unit to complete
recording management information after recording fi nishes.
You cannot change the channel or recording mode during recording.
Simultaneous recording to both DVD and VHS is not possible.
Tips
Icons such as “ [RAM] ” indicate usable
discs. Refer to pages 62 and 63.
M5821.indb8M5821.indb8 2007/05/2315:11:462007/05/2315:11:46
To Next Page
Loading...
Need help?
General
