55
USB HDD READ SEEK
Inspection
Inspecting seek time of USB HDD to inspect
performance.
At start
The [*] sign is added every approx.
10 seconds while inspecting.
Two digits on the right side are the
progress level of the inspection
(The unit is %).
Example on the way of inspection:
When USB HDD is OK after
inspection:
(NG is displayed when error is
excluding 0)
(Transfer rate is calculated from the
AV scanning result, and when it is
less than 35Mbps, NG is displayed.)
$: [X] is displayed when seek time is
over 270msec., there is error or
transfer rate is NG.
Position at $ is space when exclud-
ing those.
##: Number of data of over
100msec. and less than 270msec.
When it is over 100, [99] is
displayed.
When the number is less than 5, we
judge it normal.
When the USB HDD is not
applicable.
Press [7] [5] in service mode.
* When cancelling the inspection
mode while executing, do "forced
power-off".
Method:
Press [POWER] key on the main
unit more than 4 seconds.
Item
FL Display
Key Operation
Mode Name Description (Remote controller key)
To Next Page
Loading...
